|
Post by octopus on Sept 17, 2016 3:46:04 GMT -7
I've been treating the beastmaker 1k middle outer holds as 2-pads, bottom holds as 1-pads, and top holds as half-pads. Does anyone have their actual depth? I would like to use my previous logs as comparable data for switching to other boards at my gym.
Edit: I meant to post in Strength but I fat fingered it.
|
|
|
Post by tedwelser on Sept 17, 2016 19:42:47 GMT -7
I tried to do a google search on this question but I did not find any answers. I think the closest I found is the reddit climb harder wiki: https://www.reddit.com/r/climbharder/comments/3azo3p/small_hangboard_edges_a_select_guide/
|
|
|
Post by jessebruni on Sept 26, 2016 11:57:14 GMT -7
I can tell you the bottom outer holds are 18mm. Top holds are 14mm. Not sure about the middle two pad holds. I think once you go above a single pad it doesn't matter as much to be super precise with edge depth (i.e there's not nearly as much practical difference between a 35mm and a 40mm compared to a 20mm and a 15mm).
|
|
|
Post by jcm on Sept 27, 2016 13:55:05 GMT -7
I'm skeptical that the depth measurements are going to be all that helpful in transferring hang weights from one board to another. Hold depth is important, but it is really only one factor. There's also the texture, edge radius, slope/incut, etc. So this may be futile.
|
|
|
Post by MarkAnderson on Sept 27, 2016 17:35:27 GMT -7
I'm skeptical that the depth measurements are going to be all that helpful in transferring hang weights from one board to another. Hold depth is important, but it is really only one factor. There's also the texture, edge radius, slope/incut, etc. So this may be futile. Agreed.
|
|
|
Post by octopus on Sept 27, 2016 19:49:24 GMT -7
I appreciate the insights guys. Thanks for the measurements as well Jesse.
|
|